Kako da napravite stoličicu?
Spisak materijala:
NAPOMENA: Mere su u stopoma i inčima (1 stopa = 30, 48 cm; 1 inč = 2,54 cm)
- 1 daska širine 10 inča, dužine 3 stopa
- 1 daska širine 3 inča, dužine 2,5 stopa
- šrafovi
- lepak za drvo
- ručice (opciono)
Alat:
- metar
- libela
- olovka
- zaštitne naočare
- ubodna testera
Dimenzije:
Dimenzije stoličice možete da vidite na gornjoj slici (kliknite za uvećanje). Napomene: mere su u inčima, 1 inč = 2,54 cm
Spisak rezova:
- Od daske širine 10 inča isecite 2 komada dužine 7,5 inča, krajeve isecite pod uglom od 5 stepeni i neka budu paralelni
- Od daske širine 3 inča isecite 2 komada dužine 13 inča, krajeve isecite pod uglom od 5 stepeni i NE treba da budu paralelni
- 1 dasku širine 10 inča isecite na dužinu od 16 inča (gornji deo za sedenje)
Uputstvo za sečenje:
Korak 1: Postavljanje osnova
Bočne stranice isecite pod uglom od 5 stepeni, donji deo treba da bude širi od gornjeg. Ubodnom testerom zarežite dno.
Korak 2: Pričvrstite gornji deo
Pričvrstite gornji deo. Koristite lepak i šrafove koje ćete šrafiti sa donje strane u prethodno pod uglom izbušene rupe.
Prema ideji Ane White
2 - 1x10 @ 7-1/2" long, both ends beveled at 5 degrees off square, long point to short point, ends ARE parallel to each other
2 - 1x3 @ 13" long, both ends cut at 5 degree angles, shortest point measurement, ends NOT parallel
1 - 1x10 @ 16"
3 feet of 1x10 boards
2 and a half feet of 1x3 boards
knobs or handles (optional)
Please read through the entire plan and all comments before beginning this project. It is also advisable to review the Getting Started Section. Take all necessary precautions to build safely and smartly. Work on a clean level surface, free of imperfections or debris. Always use straight boards. Check for square after each step. Always predrill holes before attaching with screws. Use glue with finish nails for a stronger hold. Wipe excess glue off bare wood for stained projects, as dried glue will not take stain. Be safe, have fun, and ask for help if you need it. Good luck!
3 feet of 1x10 boards
2 and a half feet of 1x3 boards
knobs or handles (optional)
Please read through the entire plan and all comments before beginning this project. It is also advisable to review the Getting Started Section. Take all necessary precautions to build safely and smartly. Work on a clean level surface, free of imperfections or debris. Always use straight boards. Check for square after each step. Always predrill holes before attaching with screws. Use glue with finish nails for a stronger hold. Wipe excess glue off bare wood for stained projects, as dried glue will not take stain. Be safe, have fun, and ask for help if you need it. Good luck!
